Tuesday, June 4, 2013

North H-13 Tuning

Production is setting up for the first run of H-13 mainsails.  North Sails One Design worked hard to make a very specific set of instructions for building the sails and ensuring the quality is up to our standards.  We will have available shipping dates shortly and then can start taking orders.

In the meantime it would be a waste if we spent so much time trying to get the sails perfect, but neglected to teach our clients how to get the most out of their sails.  Moth Sailors spend hours sanding and fairing their hydrofoils, but sometimes do not spend the time fairing their aerofoil (IE their sail).  Typically walking around with a batten tensioner for a few minutes is the norm.

Here is how to try to get the most out of your North H-13 mainsail with a few simple steps.

Below is an image onboard of a North H-13 mainsail downwind.  You can see the entry angle is quite even from the top to bottom.  If your sail matches your mast, then you should have no problem achieving a similar look.  Too be critical, I probably should have added one spacer to the bottom batten.




For those sailors familiar with developing or trimming sails for skiffs or yachts you can probably understand the look of a sail with too much or too little luff curve.  If a mainsail has creases running to the middle of the mast from the clew, you know you could use a little more luff curve in that area of the sail and/or less mast bend.  A moth sail is no different, but we do have a different tool set.

The easiest change is to add or take out cam spacers which essentially is fine tuning the luff curve of the sail to match the mast.  When I get a new sail I'll do a "pinch" test at each cam to get enough spacers so that you cannot pinch more than 1-2mm of cloth in front of the mast.  If you can pinch more, then the leeward side of your luff sleeve may have wrinkles.

After pinch testing each cam, I rig the sail on the boat and go full controls on.  I look for an even entry angle on all the battens like the image below (traced from the photo above):


Perfect setup

However, sometimes you will have too much entry angle in one batten.  This causes wrinkles to project from the front of the battens above and below to the middle of the batten that needs less spacers.  See image below:


One too many spacers

The opposite can also happen where you do not have enough local luff curve and you have too fine an entry.  This causes wrinkles from the body of the sail to the front of the batten which needs spacers (the wrinkles point to where you need more spacers).  Adding a spacer then pushes out these creases.  See image below:
One too few spacers

Heavier sailors will prefer an Elite 3 mast or a Mach 2 stiff.  Lighter sailors may find a Mach 2 medium a more forgiving setup.  If you are a medium weight sailor with a Mach 2 medium mast,  the sail will come with a double hounds opening allowing for a straighter mast setup.  The double hounds opening will also allow sailors to use their double hounds rigs on this sail without having to modify their sails.